This mode enables you to set the machine to notify you through e-mail when the current copy job is done. This is especially useful when you are waiting for a large copy job to complete or when you are using the Cascade Copy mode.
|
IMPORTANT
|
|
To be able to set the Job Done Notice mode, you must first store your e-mail address in the Address Book. (See "Storing E-Mail Addresses in the Address Book (Local).")
|
1.
Place your originals → press [Options] → [Job Done Notice].
2.
Select the destination of the job done notice → press [OK].
If you select a destination that is stored with an access number, press [Access Number] and then enter the access number using 
- 
(numeric keys). If you press [Addresses without Access Number], the destinations that are not managed with an access number are displayed.
- (numeric keys). If you press [Addresses without Access Number], the destinations that are not managed with an access number are displayed.|
NOTE
|
|
For instructions on selecting a destination, see "Specifying Destinations Using the Address Book (Local)."
You cannot select multiple destinations at one time.
Once copying is complete, a job done notice is sent to the selected destination.
To display the [Access No.] key, set Access Number Management to 'On'. To access the Access Number Management setting, press
 → [Set Destination] → [Manage Address Book Access Numbers]. (See "Access Number Management.") |