The machine is provided with two power switches, a main power switch and a control panel power switch, as well as a breaker that detects excess current or leakage current.
This section explains how to turn ON the main power.
|
IMPORTANT
|
|
If you want to turn OFF the main power and then back ON again, wait for at least 10 seconds after the main power indicator is turned OFF before turning ON the main power.
|
1.
Make sure that the power plug is firmly inserted into the power outlet.
 WARNING |
|
Do not connect or disconnect the power cord with wet hands, as this may result in electrical shock.
|
2.
Press the main power switch to the "I" side.
The main power indicator on the control panel lights when the main power switch is turned ON.
When operating the main power switch, open the main power switch cover.
|
IMPORTANT
|
|
If the main power indicator on the control panel does not light even though the main power switch is ON, be sure to check the breaker to see if it is OFF. (See "When the Power Does Not Turn ON.")
|
3.
The screens shown below are displayed while the system software is loading.
If you are using a login service, log in using the procedure for the login service you are using.
|
NOTE
|
|
You can select which functions to display on the Basic Features screen when turning ON the main power, according to the Settings/Registration settings. (See "Default Screen at Startup.")
If a Macintosh, which has been shut down, is connected to the machine via a USB cable, when you turn the machine ON, the Macintosh may also turn ON. In this case, disconnect the Macintosh from the machine. (You may also be able to solve this problem by using a USB hub between the machine and the Macintosh).
If you are using Department ID Management with the Card Reader, see "Procedure before Using the Machine."
If you are using Department ID Management, see "Entering the Department ID and Password."
If you are using SSO-H, see "Using a Login Service."
|
Press the control panel power switch to cancel the Sleep mode and resume normal machine operations.
If the optional Upright Control Panel is attached, press the power switch as shown below.
|
NOTE
|
|
The machine can receive and print documents from a personal computer when it is in the Sleep mode. I-fax and fax documents can also be received while the machine is in the Sleep mode.
It takes approximately 30 seconds for the machine to recover after the Sleep mode is deactivated.
If Sleep Mode Energy Use is set to 'Low', it may take approximately 10 seconds for the touch panel display to be displayed after pressing the control panel power switch.
|
This section explains how to turn OFF the main power. If there are any jobs currently being processed, or a MEAP application is running when the Shutdown mode is activated, the machine asks you to confirm and cancel any existing jobs, and then access to the hard disk is restricted. This procedure protects the hard disk from access errors the next time the machine is turned ON. When the machine shuts down, it also performs an internal cooling down process, which enables the machine to be shut down safely.
1.
Press the main power switch of the machine to the " 
" side.
" side.
When operating the main power switch, open the main power switch cover.
|
IMPORTANT
|
|
Do not turn the main power OFF if the fax board is installed. Sending or receiving I-fax or fax documents cannot be done when the main power is turned OFF.
The machine may continue to operate during the shutdown process. Do not unplug the power cord until the main power indicator of the machine is OFF.
If the main power is turned OFF during scanning or printing, a paper jam may occur.
|