» Scan and Send » Checking/Changing a Destination
|
Checking/Changing a Destination
You can check and change a specified destination before you scan your documents.
NOTE
Only the destinations specified using the New Address and destinations obtained via an LDAP server can be changed.
For instructions on changing the specified destination after you scan your document, see "Checking and Cancelling Send Jobs."
You cannot change multiple destinations simultaneously.
1.
Select the destination → press [Details].
2.
If necessary, check or change the destination's information.
If the destination has been specified from the Local Address Book or Remote Address Book:
Check the destination's information → press [OK].
If the destination has been specified from the LDAP Server:
Check or change the destination's information → press [OK].
Change the destination's information in the same way that you specified it. (See "Specifying Destinations Using the Address Book (LDAP Server).")
If the destination has been specified using one of the sending methods in the New Destination:
Check or change the destination's information → press [OK].
Change the destination's information in the same way that you specified it. (See "Specifying Destinations Using the Address Book (Local).")
If the destination is a group address:
To check the information of registered destinations in a group address, select one destination at a time → press [Details].
Check the destination's information → press [OK] → [OK].
Back to Top