The Fax RX Report enables you to check whether documents were sent correctly from the sender's machine and received successfully by this machine. A Fax RX Report can be printed automatically after documents are received, and you can also set the machine to print a Fax RX Report only when a reception error occurs.
For information on the optional products required to use this function, see "Optional Products Required for Each Function."
|
NOTE
|
|
The reports can be printed only if A3, A4, or A4R (plain, recycled, thin, or colour paper) is loaded in a paper source whose settings in [Other] in [Paper Drawer Auto Selection On/Off] in Function Settings (from the Settings/Registration screen) are set to 'On'. However, if [Consider Paper Type] for [Copy] is set to 'On' in [Paper Drawer Auto Selection On/Off], you cannot print from a paper source with colour paper specified. (See "Setting the Paper Drawer Auto Selection On/Off.")
For an example of a Fax RX Report, see Chapter 16, "Appendix," in Getting Started.
|
1.
Press 
→ [Function Settings] → [Receive/Forward] → [Fax Settings] → [Fax RX Report].
→ [Function Settings] → [Receive/Forward] → [Fax Settings] → [Fax RX Report]. 2.
Select [For Error Only], [On], or [Off] → press [OK].
|
[For Error Only]:
|
Prints a Fax RX Report only when a reception error occurs.
|
|
[On]:
|
Prints a Fax RX Report each time a document is received.
|
|
[Off]:
|
Does not print a Fax RX Report.
|