» Network » SMB/CIFS Network Setup Procedures
|
SMB/CIFS Network Setup Procedures
To use an SMB/CIFS network, it is necessary to perform the following procedures.
1.
Protocol Settings
(See "Protocol Settings.")
Specify the protocol settings. To specify the settings, use:
The machine's control panel
The Remote UI (via a web browser)
2.
Settings for Printing/Sending a Fax
(See "Setting Up a Computer for Printing/Sending a Fax.")
Specify the settings of each computer you use for printing.
3.
Computer Settings for a File Server
(See "Setting Up a Computer as a File Server.")
Specify the settings of the computer receiving data sent from the machine.
IMPORTANT
It is recommended that steps 1 and 3 above be performed by the network administrator.
The only base protocols supported by the machine for SMB/CIFS networks are TCP/IPv4 and TCP/IPv6. NetBEUI is not supported (SMB is used as a print application).
If you are using the imagePASS, see the manual provided with the imagePASS.
If you are using the imagePASS, some functions are not available with this machine. For details, see the manual provided with the imagePASS.
Back to Top