If a paper jam occurs inside the front cover or the saddle stitcher unit of the Booklet Finisher, a screen similar to the one shown below appears on the touch panel display. Check the location of the paper jam, and follow the procedure described below, and the procedure that appears on the touch panel display, to remove the jammed paper.
1.
Open the front cover of the finisher.
If the Document Insertion/Folding Unit or Document Insertion Unit is attached, open the insertion unit. (See "Document Insertion/Folding Unit-H1/Document Insertion Unit-L1.")
2.
Open the top cover of the finisher.
* Top Cover
3.
Remove any jammed paper from the upper delivery guide.
 * Upper Delivery Guide
|
|
|
Springs are attached to the upper delivery guide, so it returns to its original position when released.
|
 CAUTION |
|
When releasing the upper delivery guide, be careful not to get your fingers caught, as this may result in personal injury.
|
4.
Remove any jammed paper from the lower delivery guide.
 * Lower Delivery Guide
|
|
5.
Close the top cover and front cover of the finisher.
 |
If you open the Document Insertion/Folding Unit or Document Insertion Unit in step 1, close the insertion unit.
|
6.
Follow the instructions on the touch panel display.
1.
Open the front cover of the finisher.
2.
Turn the small knob on the right in the direction of the arrow (counterclockwise).
3.
While pushing in the larger knob on the left, turn it in the direction of the arrow (clockwise).
4.
Remove any jammed paper protruding from the saddle stitcher unit.
5.
Remove any jammed paper from the lower delivery guide.
|
* Lower Delivery Guide
|
|
6.
Close the front cover of the finisher.
7.
Follow the instructions on the touch panel display.