You can register the method for selecting the line to use for sending.
For information on the optional products required to use this function, see "Optional Products Required for Each Function."
|
NOTE
|
|
This mode is available only if the Super G3 2nd Line Fax Board is installed.
If you select another line on the Options screen, that setting takes priority.
|
1.
Press 
→ [Function Settings] → [Send] → [Fax Settings] → [Set Line] → [Select Line Type].
→ [Function Settings] → [Send] → [Fax Settings] → [Set Line] → [Select Line Type].2.
Setting the line to use for sending.
Depending on the line, the following conditions must be met:
Line 1: Only the Super G3 FAX Board installed
Line 1, Line 2: The Super G3 FAX Board and Super G3 2nd Line Fax Board installed
|
[Priority TX]:
|
When sending, the line specified in [Priority TX] is selected if the line is not in use.
|
|
[Prohibit TX]:
|
The line specified in [Prohibit TX] is restricted. (The specified line is only used for receiving.)
|
|
IMPORTANT
|
|
The same line cannot be set for both [Priority TX] and [Prohibit TX].
Specify at least one line in [Priority TX]. You cannot set all lines in [Prohibit TX].
Even if you set to prohibit using line 1 for sending documents, line 1 is still used for fax information services.
When using manual sending, line 1 is automatically selected, regardless of the line settings.
|