Auto Redial enables the machine to automatically redial the recipient's fax number if the recipient cannot be reached due to a busy line, or if a sending error occurs.
Auto Redial can be turned 'On' or 'Off'. If you set Auto Redial to 'On', you can set how many times the machine redials, the redial interval, and whether the document should be resent due to an error.
For information on the optional products required to use this function, see "Optional Products Required for Each Function."
|
NOTE
|
|
If a sending error occurs when the receiving end answers the call, it may be because of a misdialed number. To prevent the machine from constantly redialing to the same number even though it was wrong, the machine will only redial once, regardless of the Redial Times setting. However, if the receiving end does not answer the call, the machine will dial the number of times set for the Redial Times setting.
|
1.
Press 
→ [Function Settings] → [Send] →[Fax Settings] →[Auto Redial].
→ [Function Settings] → [Send] →[Fax Settings] →[Auto Redial].2.
Select [On] or [Off].
Press [Set Details] → specify each setting → press [OK] → [OK].
<Redial Times>:
Press [-] or [+] to set the number of redial times.
<Redial Interval>:
Press [-] or [+] to set the redial interval.
<Redial When TX Error>:
|
[Error and 1st Page]:
|
Auto Redial takes place if a sending error occurs. The first page of the sending file, the error page, and all subsequent pages are resent.
|
|
[All Pages]:
|
Auto Redial takes place if a sending error occurs. All pages of the sending file are resent.
|
|
[Off]:
|
Redialing does not take place if a sending error occurs.
|
Press [OK].