This mode enables you to interrupt the current job or a reserved job to make priority copies.
This mode is useful if you need to make a rush copy during a long copy job.
|
IMPORTANT
|
|
For information on the modes which cannot be set in combination with this mode, see "Unavailable Combination of Functions."
|
|
NOTE
|
|
You can make interrupt copies whenever the machine is ready to scan.
To cancel the Interrupt mode, press [Interrupt].
To cancel previously set copy modes, press
 . (The Interrupt mode itself is not cancelled.) |
1.
Press [Interrupt].
If you want to make copies after changing the Department ID while Department ID Management is enabled, press 
(Log In/Out) → enter the Department ID and PIN using 
- 
(numeric keys). (See "Registering the Department ID, Password, and Page Limit.")
(Log In/Out) → enter the Department ID and PIN using - (numeric keys). (See "Registering the Department ID, Password, and Page Limit.")|
NOTE
|
|
The current job does not stop printing immediately after you press [Interrupt]. Printing of the current job stops only when the actual printing of the priority or interrupt copy starts.
|
2.
Place your originals → set the desired copy modes.
3.
Press 
.
.4.
Once the originals are scanned, remove them from the machine.
|
IMPORTANT
|
|
If you want to continue making interrupt copies, wait until the current interrupt copy job is complete (end of printing). Then, repeat steps 1 to 4.
|