This section describes useful send functions that enable you to perform various kinds of editing such as sending different sized originals together or two-sided originals to fit your needs.
If <Enable Fax in Scan and Send Function> is set to 'On' in Display Fax Function in Display Settings in Preferences (the Settings/Registration screen), you can also set the sender name for fax destination and the direct sending mode. (See "Display Fax Function.")
For information on setting the sender name and the direct sending mode, see "Specifying the Sender's Name When Sending Fax" and "Memory Sending and Direct Sending."
|
IMPORTANT
|
|
Depending on the mode, some combinations of modes will not be available. See the corresponding section on each mode for detailed information.
|
|
NOTE
|
|
If the Preview mode is set, you can verify the images from the Preview screen before sending your document. (See "Preview.")
To cancel all settings, press
 . |
1.
Place your originals and specify the destination.
|
IMPORTANT
|
|
Depending on the mode, you may have to place your original on the platen glass or in the feeder. See the corresponding section on each mode for detailed information.
|
2.
Press [Options].
3.
Select the desired mode from the Options screen → set the mode.
1/2
2/2
For more information on setting each mode, see the corresponding section.
To set other modes at the same time, repeat steps 2 and 3.
4.
Press [Close].