This mode enables you to repeatedly copy the entire original image in either the vertical or horizontal direction.
The following two settings are available for the Image Repeat mode.
The original image is copied so that the maximum possible number of repeats fit onto the selected paper size.
The original image is copied the specified number of times.
Example: If '3 times' is selected
Images overlap when copied.
|
IMPORTANT
|
|
For information on the modes which cannot be set in combination with this mode, see "Unavailable Combination of Functions."
|
1.
Place your originals → press [Options] → [Repeat Images].
2.
Set the number of times that you want the image to repeat for both the vertical and horizontal directions.
Press [Auto].
If [Auto] is already selected, this step is not necessary.
Press [-] or [+] to set the number of times that you want the image to repeat.
|
IMPORTANT
|
|
The repeated images may overlap or have gaps between them, depending on the number of repeats that you set.
|
3.
To specify the amount of the space between repeated images, press [Set Margins].
If you do not specify [Set Margins], proceed to step 5.
4.
Specify the amount of space between repeated images using [-] and [+].
Press [-] or [+] to set the amount of space → press [OK].
Press [Adjust Independently].
Select the space to adjust → press [-] or [+] to set its size → press [OK].
To return to the screen for setting the same amount of space for all four sides, press [Uniform Width].
5.
Press [OK].