You can reposition the stapler of the saddle stitcher unit after clearing a staple jam, or after replacing the staple cartridge. Saddle stitch staple repositioning works by feeding several sheets of paper into the saddle stitcher unit and stapling them together.
For information on the optional products required to use this function, see "Optional Products Required for Each Function."
|
IMPORTANT
|
|
Only use 279.4 mm x 431.8 mm, A3, or A4R paper for the saddle stitch staple repositioning procedure.
Make sure to remove all output booklets from the Booklet Tray before performing the saddle stitch staple repositioning procedure.
|
|
NOTE
|
|
Paper that is required for the saddle stitch staple repositioning procedure is automatically fed to the saddle stitcher unit by the machine.
[Saddle Stitcher Staple Repositioning] can be set if the Booklet Finisher is attached.
|
1.
Press 
→ [Adjustment/Maintenance] → [Adjust Action] → [Saddle Stitcher Staple Repositioning] → [Start].
→ [Adjustment/Maintenance] → [Adjust Action] → [Saddle Stitcher Staple Repositioning] → [Start].