The Fax TX Report enables you to check whether documents were sent correctly to their intended destinations. A Fax TX Report can be printed automatically after the documents are sent. You can also set the machine to print a Fax TX Report only when a transmission error occurs, and adjust the Fax TX Report setting to print the first part of the document as part of the report to remind you of the document's contents.

• This mode is available only if the optional fax board is installed.

• If TX Report in Send under <Settings> in Report Settings (from the Additional Functions screen) is set to 'For Error Only' or 'On', a Send TX Report is printed with the Fax TX Report.

• If a sequential broadcast transmission is performed when Fax TX Report is set to On, a Fax Multi TX Report is printed.

• For an example of a Fax TX Report, see Chapter 4, "Appendix," in Troubleshooting.

1. Press (Additional Functions) → [Report Settings] → [Fax] under <Settings> → [Fax TX Report].

2. Select [For Error Only], [On], or [Off].

• If you select [For Error Only] or [On]:

• If you select [Off]:

• If you select [For Error Only] or [On]:

• Select [On] or [Off] for <Report with TX Image> → press [OK].

<Report with TX Image>:

• If you select [Off]:

• Press [OK].

The Fax TX Report is not printed.

• Back To Top