Optional Equipment > Finisher-AE1/Saddle Finisher-AE2/Puncher Unit-L1/M1/N1 > Parts and Their Functions
*
Parts and Their Functions

1 Top Cover of the Finisher
Open this cover to remove jammed paper. (See "Problem Solving.")
2 Top Cover of the Puncher Unit
Open this cover to remove jammed paper. (See "Problem Solving.")
3 Front Cover of the Punch Waste Tray
Open this cover to remove punch waste or to remove jammed paper. (For instructions on removing punch waste, see "Maintenance." For instructions on clearing a paper jam, see "Problem Solving.")
4 Buffer Pass Unit-E2
Open the Buffer Pass Unit-E2 to remove jammed paper. (See "Problem Solving.")
5 Front Cover of the Finisher-AE1
Open this cover to replace the staple cartridge in the stapler unit, or to clear a staple jam. (For instructions on replacing the staple cartridge, see "Maintenance." For instructions on clearing a staple jam, see "Problem Solving.")
6 Front Cover of the Saddle Finisher-AE2
Open this cover to replace the staple cartridge, remove jammed paper, or to clear a staple jam in the stapler unit and saddle stitcher unit. (For instructions on replacing the staple cartridge in the stapler unit, see "Maintenance." For instructions on replacing the staple cartridge in the saddle stitcher unit, see "Maintenance." For instructions on clearing a paper jam, see "Problem Solving." For instructions on clearing a staple jam in the stapler unit, see "Problem Solving." For instructions on clearing a staple jam in the saddle stitcher unit, see "Problem Solving.")
7 Booklet Tray (Saddle Finisher-AE2 Only)
Prints that are saddle stitched are output to this tray.
8 Booklet Tray Guide (Saddle Finisher-AE2 Only)
Set this guide to match the size of the output paper. (See "Finishing Modes.")
9 Lower Output Tray
Prints are output to this tray. You can set the Tray Designation mode to designate this tray for outputting prints when using certain functions. (See "Additional Functions.")
10 Upper Output Tray
Prints are output to this tray. You can set the Tray Designation mode to designate this tray for outputting prints when using certain functions. (See "Additional Functions.")

  • Back To Top