After you have completed the machine protocol settings, install the printer driver on the Macintosh that will do the printing, and then make the settings for the print destination.

Specify the following settings according to the instructions in the manual for each driver.

• Depending on the machine you are using, you may have to use optional equipment to print via an AppleTalk network. For the equipment needed, see "Optional Equipment and System Requirements."

• If you want to use the UFR II printer driver

1. Installation of the UFR II printer driver
See the Mac UFR II Driver Guide.

2. Print settings
Set the machine as the print destination.

• If you want to use a PS printer driver provided by Apple Inc. with the Mac OS

1. Installation of the PPD file
See Chapter 10, "Before Printing from Computers," in Getting Started.

2. Print settings
Set the machine as the print destination.

3. Selection of the printer name
Select either of the following names displayed in the Macintosh screen. ('xxx' indicates the name of the printer entered in [Service Name].)

• [xxx_D]: the print job is printed without spooling to the hard disk of the machine.

• [xxx_S]: the print job is printed after it has been spooled to the hard disk of the machine.

• Back To Top