To use a NetBIOS network, it is necessary to perform the following procedures.

• 1 Protocol Settings (See "Protocol Settings.")

Specify the protocol settings. To specify the settings, use:

• The machine's control panel

• The Remote UI (via a web browser)

• 2 Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/Sending a Fax."

Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System Requirements.")

• 3 Computer Settings for a File Server (See "Setting Up a Computer as a File Server.")

Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to send data. For the equipment needed, see "Optional Equipment and System Requirements.")

• It is recommended that steps 1 and 3 above be performed by the network administrator.

• The only base protocol supported by the machine for NetBIOS networks is TCP/IPv4. TCP/IPv6 and NetBEUI are not supported (SMB is used as a print application).

• Back To Top