1. Check the settings for <RX/Print Range> in [IP Address Range Settings] on the IPv4 or IPv6 Settings screen to see whether the IP address of the computer in which a driver is to be installed is permitted. For details, see step 8 in "TCP/IPv4 Settings," or step 6 in "TCP/IPv6 Settings."

• If the settings for <RX/Print Range> in [IP Address Range Settings] on the IPv4 or IPv6 Settings screen do not permit the IP address, you cannot install a driver.

• If the IP address of the computer is beyond the range of the permitted addresses set for <RX/ Print Range> after installing a driver, you cannot print or send a fax from the computer.

2. Install the driver.

Install the driver according to the following procedures indicated in the manual for each driver:

• If you want to use the UFR II/PCL/PS printer driver
  See the procedure for dynamic installation in the Printer Driver Installation Guide.

• If you want to use the fax driver
  See the procedure for dynamic installation in the Fax Driver Installation Guide.

• The print application will be LPD and the print queue will be set to <LP> if the driver has been installed according to the above procedures.

• This machine enables you to specify print queues other than <LP>. You can also use Raw as the print application. For instructions on how to change the settings, see "Changing the Port after Installing the Driver."

• Back To Top