When the punch waste tray of the optional Puncher Unit-L1/M1/N1 becomes full, a screen similar to the one shown below appears on the touch panel display. Follow the procedure described below to remove the punch waste.

• This procedure is necessary only if the optional Puncher Unit-L1/M1/N1 is attached.

1. Open the front cover of the punch waste tray.

2. Pull out the punch waste tray.

3. Discard the punch waste.

• Make sure that the punch waste tray is completely emptied.

4. Return the punch waste tray to its original position.

• If the punch waste tray is not securely in place, you cannot make prints in the Hole Punch mode.

5. Close the front cover of the punch waste tray.

• When closing the front cover of the punch waste tray, be careful not to get your fingers caught, as this may result in personal injury.

• Back To Top