Finished Stamp
The machine can print a stamp (approximately 3 mm in diameter) on the front side of scanned and sent originals.
For information on the optional products required to use this function, see "Optional Products Required for Each Function."
Vertical Placement
* Position at which stamp is applied
Horizontal Placement
* Position at which stamp is applied
IMPORTANT
Place your originals in the feeder. The finished stamp is applied to the originals that are scanned from the feeder.
1.
Press [Fax].
2.
Specify the destination → press [Options] → [Finished Stamp].
NOTE
If the stamp does not print correctly, see "Replacing the Stamp Cartridge (For the DADF-AG1)."
3.
Press [Close].
» Fax » Sending/Receiving a Fax » Finished Stamp
0CYR-0U9